Remote control commands
R&S
®
RTP
1548User Manual 1337.9952.02 ─ 12
BUS<m>:ZCOupling.....................................................................................................1550
DISPlay:RESultboxes:DEPosition..................................................................................1551
BUS<m>:EXPResult:DETail.......................................................................................... 1551
BUS<m>:EXPResult:SAVE........................................................................................... 1551
BUS<m>:EXPResult:TIME............................................................................................1551
BUS<m>:TYPE <Type>
Defines the bus or protocol type for analysis. The type of available buses depends on
the installed options.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<Type> I2C | SPI | UART | CAN | CANFd | LIN | MILS1553 |
MILStd1553 | ARIN429 | ARINc429 | SWIRe | MDIO | HBTO |
USB | USBPD | ETHernet | CMSB | RFFE | DPHY | MPHY |
EBTB | USB3 | PCIE | TBTO | DDR
MILS1553 = MILStd1553: specification MIL-STD-1553
ARIN429 = ARINc429: specification ARINC 429
HBTO: Ethernet 100BASE-T1
TBTO: Ethernet 1000BASE-T1
CMSB: custom decode serial bus
EBTB: 8b/10b general decoding
SWIRe: SpaceWire
*RST:
I2C
Usage: Asynchronous command
BUS<m>[:STATe] <State>
Enables the decoding of the specified bus.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<State> ON | OFF
*RST: OFF
Usage: Asynchronous command
BUS<m>:SETReflevels
Executes the measurement of reference levels and sets the thresholds to the middle
reference level of the measured amplitude.
Protocols
To Next Page
Loading...
