Measurements
R&S
®
RTP
401User Manual 1337.9952.02 ─ 12
3. Tap "Add/Remove Measurements".
4. Disable all measurements that you do not need.
5. Select the measurements that you want to add to the quick measurement.
6. Tap "OK".
7. A "Settings" icon indicates whether further settings are required. Tap the measure-
ment. A dialog box opens, where you can adjust the measurement.
8. Tap "Set as QuickMeas" to save the setup.
The saved iQuickMeas setup is used when you start a new quick measurement.
9. "Enable" the measurement.
Set as QuickMeas
Saves the current QuickMeas setup. The saved QuickMeas configuration is used when
you start a new quick measurement. It remains until you save another QuickMeas
setup, or until you reset the instrument to "Factory defaults". The "Set as QuickMeas"
is not available if the current configuration already has been saved.
Quick measurements
To Next Page
Loading...
