Getting started
R&S
®
RTP
74User Manual 1337.9952.02 ─ 12
2. Tap the icon of the function in the toolbar.
3. Check and adjust the settings in the toolbar assist.
4. To define the analyzed area, do one of the following:
● Tap the required diagram.
● Drag a rectangle on the diagram.
3.3.6.2 Configuring the toolbar
You can configure the content of the toolbar so that only the required functions are dis-
played. Furthermore, date and time can be hidden. The toolbar configuration is part of
the user preferences. It is retained when you switch off and on the instrument, and you
can save it in the user preferences and user-defined preset.
1. To open the toolbar configuration, tap the icon in the toolbar:
2. Select the required toolbar functions:
● Disable the functions that you do not need.
● Enable the functions that you want to add to the toolbar.
A detailed description of the toolbar functions is given in Chapter 3.3.6.3, "Toolbar func-
tions", on page 74.
3.3.6.3 Toolbar functions
This section describes all toolbar functions in detail.
Operating the instrument
To Next Page
Loading...
