Rohde & Schwarz RTP044 - Page 2198

Remote control commands
R&S
®
RTP
2198User Manual 1337.9952.02 ─ 12
The setting affects only the settings of the first MSO bus (Bus1). You can set the tech-
nology value for all buses with BUS<m>:PARallel:TECHnology.
Suffix:
<m>
.
0..15
The suffix is irrelevant.
Parameters:
<Technology> V15 | V25 | V165 | V125 | V09 | VM13 | V38 | V20 | V0 | MANual
See BUS<m>:PARallel:TECHnology
DIGital<m>:THReshold <Value>
Sets the logical threshold for the channel group to which the indicated digital channel
belongs. The setting affects only the settings of the first MSO bus (Bus1).
The setting affects only the settings of the first MSO bus (Bus1). You can set the
threshold for all buses with BUS<m>:PARallel:TECHnology or BUS<m>:
PARallel:THReshold<n>.
See also: DIGital<m>:THCoupling
Suffix:
<m>
.
0..15
Number of the digital channel.
Channel groups: 0..3; 4..7; 8..11; 12..15
Parameters:
<Value> Range: -8.0 to 8.0
Increment: 200.0e-12
*RST: 0
Default unit: V
DIGital<m>:THCoupling <State>
Sets the threshold and the hysteresis for all digital channels of parallel bus 1 to the
same value.
The command BUS<m>:PARallel:THCoupling is used to set all buses.
Suffix:
<m>
.
0..15
The suffix is irrelevant.
Parameters:
<State> ON | OFF
DIGital<m>:HYSTeresis <Hysteresis>
Defines the size of the hysteresis to avoid the change of signal states due to noise for
the channel group to which the indicated digital channel belongs.
Mixed signal option (MSO, R&S
RTP-B1)