Jitter analysis and clock data recovery
R&S
®
RTP
1038User Manual 1337.9952.02 ─ 12
Table 18-2: Advanced jitter basic measurements
Measurement Abbreviation Description S
t
d
D
e
v
a
p
/
a
b
s
H
i
s
t
o
g
r
a
m
T
r
a
c
k
Symbol rate f_symb Number of data symbols per second of the ana-
lyzed signal. It is equivalent to the baud rate.
For binary signals, the signal rate is equal to the
bit rate.
X X X
Symbol duration T_symb The length of time to transfer one signal symbol.
Equals the inverse value of the symbol rate.
X X X
Event Count EC Number of analyzed data transitions.
X
Remote command:
ADVJitter<m>:DCOMposition:COMPonents<n>:ENABle on page 2271
Select all /Clear
Selects/clears all components in the basic dialog.
Remote command:
ADVJitter<m>:DCOMposition:SELBasicmeas on page 2275
ADVJitter<m>:DCOMposition:CLEBasicmeas on page 2275
18.2.5.3 Jitter measurement settings
Access: "Analysis" menu > "Advanced Jitter" > "Result" tab > "Jitter".
In the "Jitter" tab, you can add the jitter components you want to measure. You can
then enable a histogram, track or spectrum on them, see Component specific results.
Advanced jitter and noise (option R&S RTP- K133/K134)
To Next Page
Loading...
