Rohde & Schwarz RTP044 - Page 1278

Remote control commands
R&S
®
RTP
1278User Manual 1337.9952.02 ─ 12
TRIGger<m>:SPATtern:CSOurce:LEVel......................................................................... 1280
CDR:HARDware:SOURce............................................................................................ 1280
CDR:HARDware:SERStandard..................................................................................... 1280
CDR:HARDware:BREStimate........................................................................................1281
CDR:HARDware:BITRate............................................................................................. 1281
CDR:HARDware:ESLope..............................................................................................1281
CDR:HARDware:UIOFfset............................................................................................ 1281
TRIGger<m>:SERPattern:PTMDe <PatternMode>
Selects the pattern type for the serial pattern trigger.
Suffix:
<m>
.
1..3
Parameters:
<PatternMode> SBP | DBP | CBP | PRBS | EBTB | I30B | I32B
SBP
Single bit pattern
DBP
Dual bit pattern
CBP
Complex word pattern
PRBS
PRBS
EBTB
8b/10b
I32B
128b/132b
*RST:
SBP
Usage: Asynchronous command
TRIGger<m>:LEVel<n>[:VALue] <Level>
Sets the trigger level for the specified event and source.
If the trigger source is serial bus, the trigger level is set by the thresholds in the proto-
col configuration.
Suffix:
<m>
.
1..3
1 = A-trigger, 2 = B-trigger, 3 = R-trigger
Trigger