Rohde & Schwarz RTP044 - Page 1387

Remote control commands
R&S
®
RTP
1387User Manual 1337.9952.02 ─ 12
Usage: Asynchronous command
MEASurement<m>:SPECtrum:ARIThmetic:PARameter<n>:AMPTime
<ArithOp1MeasAmplitudeTime>
Selects the amplitude/time arithmetics measurements for the measurment group.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1359.
<n> 1..2
Selects the operand.
Parameters:
<Op1MeasAmpTime> HIGH | LOW | AMPLitude | MAXimum | MINimum | PDELta |
MEAN | RMS | STDDev | POVershoot | NOVershoot | AREA |
RTIMe | FTIMe | PPULse | NPULse | PERiod | FREQuency |
PDCYcle | NDCYcle | CYCarea | CYCMean | CYCRms |
CYCStddev | PULCnt | DELay | PHASe | BWIDth | PSWitching |
NSWitching | PULSetrain | EDGecount | SETup | HOLD | SHT |
SHR | CCJitter | NCJitter | CCWidth | CCDutycycle | TIE |
UINTerval | DRATe | SKWDelay | SKWPhase | DTOTrigger |
PROBemeter | SLERising | SLEFalling | ATAR
*RST: HIGH
Usage: Asynchronous command
MEASurement<m>:SPECtrum:ARIThmetic:PARameter<n>:GROup
<ArithOp2MeasGroup>
Sets the measurement group for the second operand of the spectrum arithmetic mea-
surement.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1359.
<n> 2
Parameters:
<ArithOp2MeasGroup>MEAS1 | MEAS2 | MEAS3 | MEAS4 | MEAS5 | MEAS6 |
MEAS7 | MEAS8 | IMEAS | IMEas | QUICK | QUICk
*RST: MEAS1
Usage: Asynchronous command
Automatic measurements