EasyManua.ls Logo

Rohde & Schwarz RTP044 - Page 1389

Rohde & Schwarz RTP044
2403 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Remote control commands
R&S
®
RTP
1389User Manual 1337.9952.02 ─ 12
For a detailed description, see Chapter 8.2.6.1, "Overview of eye diagram measure-
ments", on page 366.
Table 22-7: Eye diagram measurements
<MeasType>
parameter value
(remote control)
Measurement (man-
ual operation)
Description/Result Suffix
<n>
not used 1
ERPercent Extinction ratio (%) Eye base / Eye top *100
Prerequisite: Eye base > 0 and Eye top > 0
2
ERDB Extinction ratio (dB) 10*log (Eye top / Eye base) 3
EHEight Eye height Vertical eye opening 4
EWIDth Eye width Horizontal eye opening 5
ETOP Eye top Mean of the upper vertical histogram 6
EBASe Eye base Mean of the lower vertical histogram 7
not used 8...9
QFACtor Q factor (Eye top – Eye base) / (σtop + σbase) 10
not used 11...13
RMSNoise Noise (RMS) Quadratic mean of the noise of eye top and eye
base
14
SNRatio S/N ratio Signal-to-noise ratio
10 * log (Eye amplitude / Noise RMS)
15
DCDistortion Duty cycle distortion 20 * log (Eye amplitude / Noise RMS) 16
ERTime Eye rise time Duration for signal to rise from 10% to 90% of the
high signal level
17
EFTime Eye fall time Duration for signal to fall from 90% to 10% of the
high signal level
18
EBRate Eye bit rate Frequency between two crossings 19
EAMPlitude Eye amplitude Eye top - Eye base 20
not used 21...27
PPJitter Jitter (peak to peak) Average of the jitter for both crossing points
(σcrossing1 + σcrossing2) / 2
28
STDJitter Jitter (6*σ) Jitter *6 29
RMSJitter Jitter (RMS) Quadratic mean of the jitter at both crossing points 30
MEASurement<m>:EYEJitter:AUToscale........................................................................1390
MEASurement<m>:EYEJitter:LCHeck<n>:VALid.............................................................1390
MEASurement<m>:EYEJitter:LCHeck<n>:LOWer:LIMit................................................... 1390
MEASurement<m>:EYEJitter:LCHeck<n>:UPPer:LIMit....................................................1390
MEASurement<m>:EYEJitter:LCHeck<n>:LOWer:MARGin..............................................1391
MEASurement<m>:EYEJitter:LCHeck<n>:UPPer:MARGin...............................................1391
Automatic measurements

Table of Contents

Other manuals for Rohde & Schwarz RTP044

Related product manuals