Remote control commands
R&S
®
RTP
1491User Manual 1337.9952.02 ─ 12
Parameters:
<TimeDelta> Range: 0 to 10
Increment: 100E-9
*RST: 0
Default unit: s
Parameters for setting and query:
<SearchName> String with the name of the search
Usage: Asynchronous command
SEARch:TRIGger:SLEWrate:RANGe <SearchName>,<RangeMode>
SEARch:TRIGger:SLEWrate:RANGe? <SearchName>
Selects how the time limit for the slew rate is defined. The time measurement starts
when the signal crosses the first trigger level - the upper or lower level depending on
the selected slope - and stops when the signal crosses the second level.
Parameters:
<RangeMode> INSRange | OUTRange | LTHan | GTHan
INSRange
Triggers on slew rates inside a given time range. The range is
defined by "Slew rate" and "±Delta".
OUTRange
Triggers on slew rates outside a given time range. The range
definition is the same as for "Within" range.
LTHan
Triggers on slew rates shorter than the given "Slew rate" limit.
GTHan
Triggers on slew rates longer than the given "Slew rate" limit.
*RST:
GTHan
Parameters for setting and query:
<SearchName> String with the name of the search
Usage: Asynchronous command
SEARch:TRIGger:SLEWrate:SLOPe <SearchName>,<Slope>
SEARch:TRIGger:SLEWrate:SLOPe? <SearchName>
Selects the edge type.
Parameters:
<Slope> POSitive | NEGative | EITHer
See Chapter 22.4.3, "Slope parameter", on page 1147.
*RST: POSitive
Parameters for setting and query:
<SearchName> String with the name of the search
Usage: Asynchronous command
Search
To Next Page
Loading...
