Remote control commands
R&S
®
RTP
1553User Manual 1337.9952.02 ─ 12
Z1V1 | Z1V2 | Z1V3 | Z1V4 | Z1I1 | Z1I2 | Z1I3 | Z1I4 | Z2V1 |
Z2V2 | Z2V3 | Z2V4 | Z2I1 | Z2I2 | Z2I3 | Z2I4
Input channels of R&S RT-ZVCmulti-channel power probe. Only
available in the A-trigger with trigger type EDGE.
DIFF1 | DIFF2 | COMMON1 | COMMON2
Differential signals
*RST: CHAN1
Usage: Asynchronous command
TRIGger<m>:SOURce:SBSelect <SerialBus>
Selects the serial bus to be triggered on.
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event only
Parameters:
<SerialBus> SBUS1 | SBUS2 | SBUS3 | SBUS4
Usage: Asynchronous command
Firmware/software: Version 2.70
BUS<m>:TYPE <Type>
Defines the bus or protocol type for analysis. The type of available buses depends on
the installed options.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<Type> I2C | SPI | UART | CAN | CANFd | LIN | MILS1553 |
MILStd1553 | ARIN429 | ARINc429 | SWIRe | MDIO | HBTO |
USB | USBPD | ETHernet | CMSB | RFFE | DPHY | MPHY |
EBTB | USB3 | PCIE | TBTO | DDR
MILS1553 = MILStd1553: specification MIL-STD-1553
ARIN429 = ARINc429: specification ARINC 429
HBTO: Ethernet 100BASE-T1
TBTO: Ethernet 1000BASE-T1
CMSB: custom decode serial bus
EBTB: 8b/10b general decoding
SWIRe: SpaceWire
*RST:
I2C
Usage: Asynchronous command
Protocols
To Next Page
Loading...
