Acquisition and waveform setup
R&S
®
RTP
158User Manual 1337.9952.02 ─ 12
History
Due to the 16-bit word length, the history depth is reduced, less waveforms are saved
than in normal mode.
Export
In high definition mode, waveform data in raw format is exported to file with 16-bit word
length, except for peak detect decimation (2 values with 8 bit). In addition, you can
define the byte order of the data words.
You can define additional export settings in the "Menu" key >"Save/Recall" key >
"Save" tab > "Waveform" > "Setup" tab.
See:
●
"Raw (ADC direct)" on page 489
●
"Interleaved x/y" on page 490
●
"Byte order" on page 1108
If you use remote control commands to transfer data to a controlling computer, set the
data format to INT,16 to transfer the complete data words (see FORMat[:DATA]
on page 1154).
Acquire settings
To Next Page
Loading...
