Rohde & Schwarz RTP044 - Page 1729

Remote control commands
R&S
®
RTP
1729User Manual 1337.9952.02 ─ 12
Parameters:
<ThresholdLower> Range: -10 to 0
Increment: 0.01
*RST: -0.5
Default unit: V
BUS<m>:ETHernet:PRESet <ThresholdPreset>
Sets the thresholds to predefined or individually definable voltage levels.
Suffix:
<m>
.
1..4
Parameters:
<ThresholdPreset> T0 | T100 | TX0 | TX100 | MANual
T0
Sets the thresholds to the default values for 10BASE-T
(0 meters): upper threshold to 1.25 V, lower threshold to -1.25 V
T100
Sets the thresholds to the default values for 10BASE-T
(100 meters): upper threshold to 0.75 V, lower threshold to
-0.75 V
TX0
Sets the thresholds to the default values for 100BASE-TX
(0 meters): upper threshold to 0.5 V, lower threshold to -0.5 V
TX100
Sets the thresholds to the default values for 100BASE-TX
(100 meters): upper threshold to 0.35 V, lower threshold to
-0.35 V
MANual
Allows to set individual threshold voltage levels
*RST:
T0
BUS<m>:ETHernet:BITRate <BitRateValue>
Sets the bit rate value that defines the transmission speed in bits per second.
Suffix:
<m>
.
1..4
Parameters:
<BitRateValue> Range: 10000 to 150000000
Increment: 1000
*RST: 10000000
Default unit: bps
Protocols