Remote control commands
R&S
®
RTP
2028User Manual 1337.9952.02 ─ 12
SEARch:TRIGger:USB:DPOPerator <SearchName>,<DataPosOperator>
SEARch:TRIGger:USB:DPOPerator? <SearchName>
Sets the operator (any or equal) for the payload data index position.
Parameters:
<DataPosOperator> ANY | OFF | EQUal
ANY = OFF
The position of payload data is not relevant for the search condi-
tion.
*RST: ANY
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:USB:DPOSition
<SearchName>,<DataPosition>
SEARch:TRIGger:USB:DPOSition? <SearchName>
Specifies the position within a payload data packet, in which a special data pattern is to
be searched.
Parameters:
<DataPosition> Range: 0 to 1024
Increment: 1
*RST: 0
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:USB:ECONdition <SearchName>,<EndpointOptor>
SEARch:TRIGger:USB:ECONdition? <SearchName>
Sets the operator to set a specific endpoint or an endpoint range. The endpoint values
are set with SEARch:TRIGger:USB:EMIN and SEARch:TRIGger:USB:EMAX.
Parameters:
<EndpointOptor> OFF | ANY | EQUal | NEQual | LTHan | LETHan | GTHan |
GETHan | INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less than or equal, Greater than,
Greater than or equal. These conditions require one endpoint
value to be set using SEARch:TRIGger:USB:EMIN.
INRange | OORange
In range, out of range. These conditions require a range of end-
point values to be set using SEARch:TRIGger:USB:EMIN and
SEARch:TRIGger:USB:EMAX.
*RST: OFF
Parameters for setting and query:
<SearchName>
Protocols
To Next Page
Loading...
