Remote control commands
R&S
®
RTP
2206User Manual 1337.9952.02 ─ 12
Suffix:
<m>
.
1 | 2
Selects the parallel bus. The clocked bus is available on parallel
buses 1 and 2.
Parameters:
<ClockSource> D0 | D1 | D2 | D3 | D4 | D5 | D6 | D7 | D8 | D9 | D10 | D11 | D12 |
D13 | D14 | D15
Clock channel
*RST: D1
BUS<m>:PARallel:CLSLope
<ClockSlope>
Selects the slope of the clock signal at which all digital channels of the bus are ana-
lyzed.
Suffix:
<m>
.
1 | 2
Selects the parallel bus. The clocked bus is available on parallel
buses 1 and 2.
Parameters:
<ClockSlope> POSitive | NEGative | EITHer
*RST: POSitive
BUS<m>:PARallel:CLEar
Removes all assigned digital channels from the bus
Suffix:
<m>
.
1..4
Selects the parallel bus.
Usage: Event
BUS<m>:PARallel:DECTable<n>:SHOW <ShowDecodeTable>
Available only if BUS<m>:PARallel:CLON is set to ON.
If enabled, a results box opens with decoded values of the bus signal and its time. You
can query the number of values (BUS<m>:PARallel:DECTable<n>:COUNt?) and
their data value (BUS<m>:PARallel:DECTable<n>:DATA?).
Suffix:
<m>
.
1..4
<n> 1..5
Parameters:
<ShowDecodeTable> ON | OFF
*RST: OFF
Mixed signal option (MSO, R&S RTP-B1)
To Next Page
Loading...
