Mask testing
R&S
®
RTP
441User Manual 1337.9952.02 ─ 12
The "Masks" toolbar assist opens.
2. Tap the corner points of the mask segment on the touch screen.
Tip: To create an exact rectangle, draw the diagonal of the rectangle on the
screen.
3. Tap "Finish segment".
Now you can enter another segment to the current mask test or add a new mask
test.
4. To finish the mask definition, close the toolbar assist.
If the acquisition is running, the mask test starts automatically and immediately.
To create a mask numerically in the dialog box
The settings mentioned here are described in detail in Chapter 10.2.1, "Define mask",
on page 426.
1. Open [App Cockpit] > "Analysis" tab > "Mask" > "Define Mask" tab.
2. Create a mask test:
a) Tap the "+"-icon in the upper right corner.
b) Enter a name for the new mask test.
A new, empty tab for the mask test appears.
3. Set "Mask type"= "User".
4. Tap "Setup mask".
5. In the "User Mask: Segments" area, tap "Insert" to create a new mask segment.
6. Set the corner points of the mask segment:
a) Select the "Segment".
b) Tap "Configure". The "User Mask: Points" dialog opens.
c) In the "Definition of segment" area, tap "Insert".
Point 1 appears.
d) Tap the X-cell and enter the X-value of the point.
e) Tap the Y-cell and enter the Y-value of the point.
f) To insert the next point:
● Tap "Insert" to add a point before the selected point.
● Tap "Append" to add a point at the end of the list.
g) Set the X- and Y-values for this point.
h) Repeat the last two steps until you define all points.
7. In the "Define Mask" tab, tap "Enable".
Working with masks
To Next Page
Loading...
