Search functions
R&S
®
RTP
463User Manual 1337.9952.02 ─ 12
The toolbar assist opens.
3. Tap the diagram with the waveform to be searched, or drag a rectangle on the dia-
gram to define the search area.
4. Alternatively, use the settings provided in the toolbar assist.
The default edge search is configured as "Search<x>" and performed. The "Search
Results" box is displayed.
To create a user-defined search
1. Open the search dialog: "Menu" > "Apps" > "Analysis" tab > "Search".
2. There are two ways to create a search:
● If you want to create a new, unconfigured search, tap the "Add" icon.
● If you want to create a new search based on an existing one, tap the "Copy"
icon.
3. Enter a name for the search using the on-screen keyboard.
To configure a user-defined search
1. Open the search dialog: "Menu" > "Apps" > "Analysis" tab > "Search".
2. Select the "Setup" tab and the search you want to configure.
3. Select the "Source" on which you want to perform the search.
4. Select the events you want to include in the search.
5. Define the settings of the first search event.
To use the same conditions as defined in the trigger configuration of the A-event,
tap "Copy from trigger A'". The selected trigger settings are applied to the search
settings.
6. Repeat the previous steps to define further events for the same search.
7. To perform the search only on a part of the waveform, configure the gate in the
"Gate" tab as described in Chapter 11.3.2, "Defining the search gate",
on page 466.
Search setup
To Next Page
Loading...
