Rohde & Schwarz RTP044 - Page 48

Getting started
R&S
®
RTP
48User Manual 1337.9952.02 ─ 12
11 = USB connectors
12 = Connectors for probe compensation and grounding
13 = [Power] key
The keys and controls are described in Chapter 3.2.3, "Keys and controls",
on page 52.
3.2.1.1 Connectors
Channel inputs and external trigger input
The R&S RTP has four channel inputs to connect the input signals, and an external
trigger input to control the measurement by an external signal.
The input connectors are provided with a special Rohde & Schwarz active probe inter-
face, and they are BNC compatible. Thus, the instrument can automatically detect
active probes that have the Rohde & Schwarz probe interface.
The maximum input voltage on channel inputs and the external trigger input is
5 V peak. The input impedance of the inputs is 50 Ω.
USB
Two USB type A connectors that comply with standard USB 3.1 gen 1. They are used
to connect devices like keyboard, mouse and USB flash drive.
Note: Electromagnetic interference (EMI) can affect the measurement results. To avoid
any impact, do not use USB connecting cables exceeding 1 m.
Probe Compensation
Probe compensation terminal to support adjustment of passive probes to the oscillo-
scope channel.
Protective earth conductor, 4 mm banana jack to connect ground of
DUT and test fixtures, and wrist strap.
Square wave signal for probe compensation, 1 kHz and 1 V
pp
.
Ground connector for probes.
3.2.1.2 Option slots
Three options R&S RTP-B1/B6/B7 can be installed in one R&S RTP - two at the front
panel, and one at the rear panel. Each option can be installed only once, and the slot
assignment depends on the available options. To ensure correct installation and cali-
bration, installation is done only at Rohde & Schwarz service centers.
See also: "Option slot" on page 52.
Instrument tour