Getting started
R&S
®
RTP
66User Manual 1337.9952.02 ─ 12
Figure 3-7: Signal label
1 = Vertical scale
2 = Offset
3 = Bandwidth
4 = Coupling
5 = Termination
If the signal bar contains many icons and not all icons are visible, touch one of the
icons and scroll left or right until the required icon appears.
You can also switch off the signal bar: "Menu" > "Settings" > "Appearance" > "Diagram"
> "Show signal bar".
Histogram and histogram area
A histogram shows the frequency of occurrence of voltage or time values in a bar chart
directly in the diagram. The rectangular histogram area indicates the part of the wave-
form that is considered in the histogram. The vertical histogram counts the voltage val-
ues, and the horizontal histogram counts time values. You can switch between vertical
and horizontal mode, and modify the histogram area by dragging the rectangle as a
whole, by dragging its edges, or by setting exact positions.
3.3.2.2 Control elements on the touchscreen
The touchscreen provides everything you need to control the instrument, to analyze
waveforms, and to get measurement results. Figure 3-8 shows the control elements on
a glance.
Operating the instrument
To Next Page
Loading...
