Rohde & Schwarz RTP044 - Page 773

Protocol analysis
R&S
®
RTP
773User Manual 1337.9952.02 ─ 12
Remote command:
SEARch:TRIGger:CMSB:ERRor<m>:ENABle on page 1964
SEARch:TRIGger:CMSB:FIENable on page 1964
SEARch:TRIGger:CMSB:FRAMe<m>:ENABle on page 1966
SEARch:TRIGger:CMSB:FRENable on page 1964
SEARch:TRIGger:CMSB:FRAMe<m>:FLD<n>:BIT on page 1964
SEARch:TRIGger:CMSB:BIT on page 1964
SEARch:TRIGger:CMSB:FRAMe<m>:FLD<n>:DMAX on page 1965
SEARch:TRIGger:CMSB:DMAX on page 1965
SEARch:TRIGger:CMSB:FRAMe<m>:FLD<n>:DMIN on page 1965
SEARch:TRIGger:CMSB:DMIN on page 1965
SEARch:TRIGger:CMSB:FRAMe<m>:FLD<n>:DOPerator on page 1966
SEARch:TRIGger:CMSB:DOPerator on page 1966
SEARch:TRIGger:CMSB:FRAMe<m>:FLD<n>:IMAX on page 1967
SEARch:TRIGger:CMSB:IMAX on page 1967
SEARch:TRIGger:CMSB:FRAMe<m>:FLD<n>:IMIN on page 1967
SEARch:TRIGger:CMSB:IMIN on page 1967
SEARch:TRIGger:CMSB:FRAMe<m>:FLD<n>:IOPerator on page 1967
SEARch:TRIGger:CMSB:IOPerator on page 1967
Error Condition
Searches for two error conditions: "CRC Error" or "Parity Error".
Remote command:
SEARch:TRIGger:CMSB:ERRor<m>:ENABle on page 1964
13.15.6.2 Custom serial bus search results
To get search results, "Enable" the search. You can minimize, shift or close the search
dialog.
The search results are listed in the search result table and marked in the waveform by
blue lines.
For an introduction to search results, see:
●
Chapter 11.1.2, "Search results", on page 449
●
Chapter 11.4.2, "Display zoom settings", on page 468
Remote commands are listed in Chapter 22.17.16.6, "Search results", on page 1968
13.15.6.3 Searching custom serial bus data
Prerequisite: A serial bus is configured for the custom serial bus signal to be decoded
and analyzed.
The search for events is set up in the following way:
1. Press the [Protocol] key and selet the "Shortcuts" tab.
2. Tap "Setup search".
Custom: Manchester / NRZ (option R&S
RTP-K50)M