Getting started
R&S
®
RTP
82User Manual 1337.9952.02 ─ 12
Go back: opens the previously opened dialog box.
Go forward: opens the next dialog box.
Minimizes the dialog box to a small box that only contains the last selected function.
Closes the dialog box.
For direct access to important control and measurement functions, use the toolbar, see
Chapter 3.3.6, "Toolbar", on page 73.
To open a dialog box
► Perform one of the following actions:
● Open the "Menu", and select the menu entry.
● Press the function key on the front panel.
●
Double-tap a result icon, or tap the icon in a result box to open the corre-
sponding dialog box.
● To open the "Vertical" dialog box of a waveform, tap the signal icon.
● Tap the "Horizontal", "Acquistion" or "Trigger" label to open the corresponding
dialog box.
To minimize a dialog box
If you want to change only one setting during analysis, and you need to change it
often, you can display a small box that only contains the required setting.
1. Tap the setting that you need to modify.
2. Tap the "Minimize" icon in the upper right corner of the dialog box.
The dialog box turns into a small box that contains only the setting, that was last
selected.
3. To restore the complete dialog box, tap the "Maximize" icon in the small box.
Operating the instrument
To Next Page
Loading...
