Rohde & Schwarz RTP044 - Page 893

Protocol analysis
R&S
®
RTP
893User Manual 1337.9952.02 ─ 12
"CRC16 error"
Triggers on 16-bit cyclic redundancy check (CRC) errors.
"LCRC error"
Triggers on link cyclic redundancy check (LCRC) errors.
"ECRC error"
Triggers on end-to-end cyclic redundancy checksum (ECRC) errors.
"Unknown
packet"
Triggers on an unknown packet.
"Length error"
Triggers on a length error , for frames that do not have the specified
length or data.
"Malformed
error"
Triggers on a malformed TLP: a TLP that violates specific TLP forma-
tion rules that are defined in the specification.
"Value out of
range"
Triggers, if a value of a field is out of the range defined by the PCIe
standard.
"Prefix order
error"
Triggers on a wrong prefix order.
"Max end to
end prefix"
Triggers on an end-end prefix error. The maximum number of permit-
ted end-end TLP prefixes is 4.
"Sync bit"
Triggers on a sync bit.
Remote command:
TRIGger<m>:PCIE:ERRC:LENGth on page 2136
TRIGger<m>:PCIE:ERRC:MALFormed on page 2136
TRIGger<m>:PCIE:ERRC:MXPFix on page 2136
TRIGger<m>:PCIE:ERRC:PFORder on page 2136
TRIGger<m>:PCIE:ERRC:SYCBit on page 2136
TRIGger<m>:PCIE:ERRC:UKNP on page 2136
TRIGger<m>:PCIE:ERRC:VOORange on page 2136
13.22.4.2 Triggering on PCIe Gen 1/2
Prerequisite: A bus is configured for the PCIe Gen 1/2 signal to be analyzed.
PCIe (option R&S
RTP-K72/K73)