Configuration Guide TACACS+ Commands
Use this command to configure the authentication encryption key used for TACACS+
communications between the access server and the TACACS+ server.
Use the no form of this command to remove the authentication encryption key.
tacacs-server key [ 0 | 7 ] string
Encryption type of key
0 indicates no encryption; 7 indicate simple encryption.
No authentication encryption key is configured by default.
Global configuration mode
Use command to configure a global authentication and encryption key for TACACS+ communication.
Use the key parameter in the tacacs-server host command to configure a server-based key.
The following example defines the authentication encryption key of TACACS+ server as aaa:
Ruijie(config)# tacacs-server key aaa
3.7 tacacs-server timeout
Use this command to set the interval for which the server waits for a server host to reply. Use the no
form of this command to restore the default timeout interval.
tacacs-server timeout seconds
To Next Page
Loading...
Need help?
General