Command Reference Line Commands
3.23 parity
Use this command to configure the parity for the async line. Use the no form of this command to
restore the default setting.
parity { even | none | odd }
No parity check is configured by default.
Parity is required in communication through some devices (such as async serial ports and console
ports).
The following example configures even parity for the async line.
Ruijie(config)#line console 0
Ruijie(config-line)#parity even
Use this command to set the privilege level for the line. Use the no form of this command to restore
the default setting.
Privilege level, in the range from 0 to 15.
To Next Page
Loading...
