Command Reference Voice VLAN Commands
Use this command to enable Voice VLAN in the global configuration mode. Use the no form of this
command to restore the default setting.
This function is disabled by default.
Global configuration mode
Use this command to enable the Voice VLAN and specify the Voice VLAN ID.
1. The corresponding VLAN shall be created before configuring the Voice VLAN;
2. The default VLAN is VLAN1 and cannot be set as the Voice VLAN;
3. A VLAN is not allowed to be set as the Voice VLAN and the Super VLAN at the same time;
4. With 802.1x VLAN auto-switching function enabled, the assigned VID shall not be set as the
Voice VLAN ID;
5. RSPAN Remote VLAN and Voice VLAN cannot be the same VLAN, or it influences the
remote port mirror and the Voice VLAN function.
The following example sets the VLAN2 as the Voice VLAN.
Ruijie(config)# vlan 2
Ruijie(config-vlan)# exit
Ruijie(config)# voice vlan 2
Display Voice VLAN configurations and the
current state.
To Next Page
Loading...
Need help?
General