Command Reference Line Commands
3.36 terminal flowcontrol
Use this command to configure the flow control mode for the current terminal. Use the no form of this
command to restore the default setting.
terminal flowcontrol { hardware | none | software }
terminal no flowcontrol { hardware | none | software }
Configures hardware flow control.
Configures no flow control.
Configures software flow control.
The default flow control mode is none.
The following example configures software flow control for the current terminal.
Ruijie#terminal flowcontrol software
Use this command to enable command history for the current terminal or set the number of
commands in the command history. Use the no history command to disable command history. Use
the no history size command to restore the number of commands in the command history to the
default setting.
terminal history [ size size ]
To Next Page
Loading...
Need help?
General