Command Reference Interface Commands
1 Interface Commands
1.1 bandwidth
Use this command to set the bandwidth on the interface. Use the no form of this command to restore
the default setting.
Bandwidth per second, in the unit of Kbps.
If this command is not configured on the interface, use the show interface command to display the
default setting in privileged EXEC mode.
Interface configuration mode
This command does not affect the actual bandwidth on the interface. Instead, it is used to display the
system the bandwidth specification. By default, the bandwidth is determined by the actual link rate on
the interface. It can be set by the user as well.
The following example sets the bandwidth on the interface to 64 Kbps.
Ruijie(config)#interface gigabitEthernet 0/1
Ruijie(config-if-GigabitEthernet 0/1)# bandwidth 64
Use this command to set the carrier delay on the interface. Use the no form of this command to
restore the default value.
carrier-delay { [ milliseconds ] num | up [ milliseconds ] num down [ milliseconds ] num}