Ruijie RG-S29 Series User Manual

Command Reference NTP Commands
source.
Configuration
Examples
The following example configures the device to act as an authoritative NTP server, and sets the
stratum level to 12:
Ruijie(config)# ntp master 12
Related
Commands
Command
Description
N/A
N/A
Platform
Description
N/A
3.7 ntp server
Use this command to specify a NTP server for the NTP client. Use the no form of this command to
delete the specified NTP server.
ntp server { ip-addr | domain | ip domain | ipv6 domain } [ version version ] [ source if-name ] [ key
keyid ] [ prefer ]
no ntp server ip-addr
Parameter
Description
Parameter
Description
ip-addr
Sets the IP address of the NTP server. The address can be in IPv4 or
IPv6 format.
domain
Sets the domain name of the NTP server, supporting IPv4 and IPv6.
version
(Optional) Specifies the NTP version (1-3). The default is NTPv3.
if-name
(Optional) Specifies the source interface from which the NTP
message is sent (L3 interface).
keyid
(Optional) Specifies the encryption key adopted when communication
with the corresponding server. The key ID range is from 1 to
4,294,967,295.
prefer
(Optional) Specifies the given NTP server as the preferred one.
Defaults
No NTP server is configured by default.
Command
mode
Global configuration mode.
Usage Guide
At present, RGOS system only supports clients other than servers. Up to 20 servers can be
synchronized.
To carry out the encrypted communication with the server, set the global encryption key and global
trusted key firstly, and then specify the corresponding key as the trusted key of the server to launch

Ruijie RG-S29 Series Specifications

General

Brand	Ruijie
Model	RG-S29 Series
Category	Switch
Language	English