Configuration Guide 802.1X Commands
4.19 dot1x critical recovery action reinitialize
Use this command to allow IAB users under the port to reinitialize authentication when the server has
recovered.
Use the no form of this command to restore the default setting.
dot1x critical recovery action reinitialize
no dot1x critical recovery action reinitialize
This function is disabled by default.
Interface configuration mode
After the port entering the inaccessible authentication bypass status, if the RADIUS server returns to
normal, you need to reinitialize the authentication for all users that have accomplished the network
access authorization through the inaccessible authentication bypass on ports in order to ensure the
user legality.
The following example allows IAB users under the port to reinitialize authentication when the server
has recovered.
Ruijie(config-if-GigabitEthernet 0/5)#dot1x critical recovery action
reinitialize
Use this command to configure the port in IAB status to jump to a specified auth-fail VLAN.
Use the no form of this command to disable this function.
To Next Page
Loading...
