Command Reference Line Commands
3.42 terminal start-character
Use this command to configure the start character for software flow control on the current terminal.
Use the no form of this command to restore the default setting.
terminal start-character ascii-value
terminal no start-character
Sets the ASCII value corresponding to the start character for software
flow control on the current terminal, in the range from 0 to 255.
The default is Ctrl+Q (ASCII: 17).
The following example configures Ctrl+Y (ASCII: 25) for starting software flow control on the current
device,
Ruijie#terminal start-character 25
Use this command to set the stopbit number of every character for the current terminal. Use the no
form of this command to restore the default setting.
terminal stopbits { 1 | 2 }
To Next Page
Loading...
Need help?
General