Command Reference Syslog Commands
8.9 logging delay-send terminal
Use this command to enable delay in sending logs to console and remote terminal. Use the no form
of this command to restore the default setting.
logging delay-send terminal
no logging delay-send terminal
This function is disabled by default.
Global configuration mode
The following example enables delay in sending logs to console and remote terminal.
Ruijie(config)# logging delay-send terminal
8.10 logging facility
Use this command to configure the device value of the log information in global configuration mode.
Use the no form of the command to restore the default setting.
logging facility facility-type
no logging facility
Syslog device value. For specific settings, refer to the usage
guide.
The default is 23 if the RFC5424 format is enabled (Local7, local use).
To Next Page
Loading...
