Ruijie RG-S29 Series User Manual

Command Reference VRRP Commands
Description
4.11 vrrp priority
Use this command to specify the priority of the VRRP group.
Use the no form of this command to restore the default setting.
vrrp [ ipv6 ] group priority level
no vrrp [ ipv6 ] group priority
Parameter
Description
Parameter
Description
ipv6
Specifies the priority of the IPv6 VRRP group.
group
VRRP group number
level
VRRP group priority
Defaults
This function is disabled by default. Once the VRRP function is enabled, the default priority of the
VRRP group is 100.
Command
Mode
Interface configuration mode
Usage Guide
N/A
Configuration
Examples
The following example sets the priority of IPv4 VRRP group 1 as 254.
Ruijie#configure terminal
Ruijie(config)#interface GigabitEthernet 0/0
Ruijie(config-if-GigabitEthernet 0/0)#no switchport //used on the switch.
Ruijie(config-if-GigabitEthernet 0/0)#ip address 10.0.1.1 255.255.255.0
Ruijie(config-if-GigabitEthernet 0/0)#vrrp 1 ip 10.0.1.20
Ruijie(config-if-GigabitEthernet 0/0)#vrrp 1 priority 254
The following example sets the priority of IPv6 VRRP group 1 as 254.
Ruijie#configure terminal
Ruijie(config)#interface GigabitEthernet 0/0
Ruijie(config-if-GigabitEthernet 0/0)#no switchport //used on the switch.
Ruijie(config-if-GigabitEthernet 0/0)#ipv6 enable
Ruijie(config-if-GigabitEthernet 0/0)#ipv6 address 2001::2/64
Ruijie(config-if-GigabitEthernet 0/0)#vrrp 1 ipv6 FE80::1
Ruijie(config-if-GigabitEthernet 0/0)#vrrp 1 ipv6 2001::1
Ruijie(config-if-GigabitEthernet 0/0)#vrrp ipv6 1 priority 254
Related
Commands
Command
Description
vrrp group ip ipaddress [ secondary ]
Enables the VRRP function and set the IP
address for the virtual device.
vrrp group preempt [ delay seconds ]
Sets the VRRP in the preemption mode.

Ruijie RG-S29 Series Specifications

General

Brand	Ruijie
Model	RG-S29 Series
Category	Switch
Language	English