Ruijie RG-S29 Series

Command Reference PoE Management Commands
14.9 poe priority
Use this command to set the PoE priority for the port. Use the no or default form of this command to
restore the default setting.
poe priority { low | high | critical }
no poe priority
default poe priority
Parameter
Description
Parameter
Description
{ low | high | critical }
Priority level.
Defaults
The default is low.
Command
Mode
Interface configuration mode
Usage Guide
N/A
Configuration
Examples
The following example sets the PoE priority for port GigabitEthernet 0/1 to critical.
Ruijie(config)# interface GigabitEthernet 0/1
Ruijie(config-if-GigabitEthernet 0/1)# poe priority critical
Ruijie(config-if-GigabitEthernet 0/1)# end
Related
Commands
Command
Description
N/A
N/A
Platform
Description
N/A
14.10 poe uninterruptible-power
Use this command to configure uninterruptible warm start, Use the no or default form of this
command to restore the default setting.
poe uninterruptible-power
no poe uninterruptible-power
default no poe uninterruptible-power
Parameter
Description
Parameter
Description
N/A
N/A