Configuration Guide 802.1X Commands
Only the specified interface with the specified MAC address is able to pass the 802.1x authentication.
The following example configures the authentication address table.
Ruijie(config)# dot1x auth-address-table 00d0.f800.0cb2 interface
fastethernet 0/1
Use this command to configure the authentication method list.
dot1x authentication list-name
Authentication method list
Global configuration mode
If AAA does not adopt the default 802.1X authentication, use this command to configure the 802.1X
authentication method.
Configuration in WLAN security configuration mode is prior to that in global configuration mode.
The following example configures the authentication method list
Ruijie(config)# dot1x authentication dot1x-authen
4.9 dot1x auth-fail max-attempt
Use this command to set the maximum auth-attempts.
Use the no form of this command to restore the default setting.
To Next Page
Loading...
Need help?
General