Command Reference OSPFv3 Commands
3.8 clear ipv6 ospf process
Use this command to clear and restart the OSPF process.
clear ipv6 ospf { process | process-id ]
OSPF process ID, in the range from 1 to 65535
In normal case, it is not necessary to use this command.
Use the parameter process-id to clear only one specific OSPFv3 instance. If no process-id is
specified, all the OSPFv3 instances will be cleared.
The following example restarts the OSPF process.
enble
clear ipv6 ospf process
3.9 default-information originate
Use this command to generate a default route to the OSPFv3 routing domain in the routing process
mode. Use the no form of this command to restore the default setting.
default-information originate [ always ] [ metric metric ] [ metric-type type ] [ route-map
map-name ]
no default-information originate [ always ] [ metric ] [ metric-type ] [ route-map map-name ]
( Optional ) It makes OSPFv3 generate the default route
To Next Page
Loading...
Need help?
General