Ruijie RG-S29 Series

Command Reference OSPFv3 Commands
Related
Commands
Command
Description
ipv6 router ospf
Starts the OSPFv3 routing process.
default-information originate
Sets the default route to be redistributed.
default-metric
Sets the default metric for the route to be
redistributed.
router-id
Sets the OSPFv3 routing process ID
timers spf
Sets the delay and the minimum and maximum
intervals for the OSPFv3 to perform SPF
calculation after receiving the topology change
information.
Platform
Description
N/A
3.38 show ipv6 ospf database
Use this command to display the database information of the OSPFv3 process
show ipv6 ospf [ process- id ] database [ lsa-type [ adv-router router-id ] ]
Parameter
Description
Parameter
Description
process- id
OSPF process ID number
lsa-type
The LSA types are as follows:
NSSA-external-LSA, AS-external-LSAs, Link-LSAs,
Inter-Area-Prefix-LSAs, Inter-Area-Router-LSAs,
Intra-Area-Prefix-LSAs, Network-LSAs, Router-LSAs
If this parameter is not specified, all LSA information will be displayed.
adv-router router-id
Displays the LSA information generated by the specified router.
Defaults
N/A
Command
Mode
Privileged EXEC mode.
Usage Guide
N/A
Configuration
Examples
The following example displays the information about the OSPFv3 process database.
Ruijie# show ipv6 ospf database
OSPFv3 Router with ID (1.1.1.1) (Process 1)
Link-LSA (Interface FastEthernet 1/0)
Link State ID ADV Router Age Seq# CkSum Prefix
0.0.0.2 1.1.1.1 197 0x80000001 0x7cd8 0