Configuration Guide DHCPv6 Snooping Commands
This command is used to clear the statistical information of the DHCPv6 packets.
The following example clears the statistical information of the DHCPv6 packets.
Ruijie# clear ipv6 dhcp snooping statistics
Ruijie# show ipv6 dhcp snooping statistics
Packets Processed by DHCPv6 Snooping = 0
Packets Dropped Because
Received on untrusted ports = 0
Relay forward = 0
No binding entry = 0
Binding fail = 0
Unknown packet = 0
Unknown output interface = 0
No enough memory = 0
Admin filter-dhcpv6-pkt = 0
Use this command to enable the DHCPv6 Snooping function globally.
Use the no form of this command to restore the default setting.
This function is disabled by default.
Global configuration mode
The show ip dhcpv6 snooping command is used to display whether the DHCPv6 Snooping function
is enabled.
To Next Page
Loading...
Need help?
General