Command Reference IGMP Snooping Commands
No range is defined for a profile by default.
Profile configuration mode
A profile is used to filter a group of multicast packets, so as to assist other features.
Configuration steps:
1. Use the ip igmp profile command to create a profile and enter profile configuration mode.
2. Use the range command to define a range for the profile.
3. Use the permit command to permit the multicast forwarding for the profile.
The following is an example of allowingpermits the forwarding of the multicast streams from 224.2.2.2
to 224.2.2.244: of profile 1.
Ruijie(config)# ip igmp profile 1
Ruijie(config-profile)# range 224.2.2.2 224.2.2.244224.2.2.2
Ruijie(config-profile)# permit
2.32 show ip igmp profile
Use this command to display the profile information.
show ip igmp profile
show ip igmp profile profile-number
Displays configuration information of the designated profile.
Use this command to display the profile information.
The following example displays the profile information.
Ruijie(config-if)# show ip igmp profile
Profile 1
Permit
range 224.0.1.0, 239.255.255.255
To Next Page
Loading...
Need help?
General