Ruijie RG-S29 Series

Command Reference NTP Commands
3 NTP Commands
3.1 no ntp
Use this command to disable Network Time Protocol (NTP), and clear all NTP configuration.
no ntp
Parameter
Description
Parameter
Description
N/A
N/A
Defaults
NTP is disabled by default.
Command
mode
Global configuration mode.
Usage Guide
By default, NTP is disabled. However, once the NTP server or the NTP authentication is configured,
the NTP service will be enabled.
Configuration
Examples
The following example disables NTP.
Ruijie(config)#no ntp
Related
Commands
Command
Description
ntp server
Specifies an NTP server.
Platform
Description
N/A
3.2 ntp access-group
Use this command to configure an access group to control NTP access. Use the no form of this
command to remove the peer access group.
ntp access-group { peer | serve | serve-only | query-only } access-list-number | access-list-name
no ntp access-group { peer | serve | serve-only | query-only } access-list-number |
access-list-name
Parameter
Description
Parameter
Description
peer
Allows the device to receive time requests and NTP control queries to
synchronize itself to the servers specified in the access list.