Command Reference Basic Configuration Management Commands
This command is used to configure a prompt message. The system discards all the characters next to
the terminating symbol.
When you are logging in to the device, the MOTD message is displayed at first, and then the banner
login message. After you have logged in, the welcome message or the prompt message is displayed.
If it’s a reverse Telnet session, the prompt message is displayed. Otherwise, the welcome message is
displayed.
The following example configures a prompt message for reverse Telnet session.
Ruijie(config)# banner incoming $ Welcome $
Use this command to configure a login banner. Use no form of this command to r remove the setting.
Separator of the message contained in the login banner. Delimiters
are not allowed in the MOTD.
Contents of the login banner
Global configuration mode
This command sets the login banner message, which is displayed at login. The system discards all
the characters next to the terminating symbol.
The following example configures a login banner.
Ruijie(config)# banner login $ enter your password $
To Next Page
Loading...
