Ruijie RG-S29 Series

Command Reference GVRP Commands
10 GVRP Commands
10.1 bridge-frame forwarding protocol gvrp
Use this command to enable GVRP PDUs transparent transmission. Use the no form of this
command to restore the default setting.
bridge-frame forwarding protocol gvrp
no bridge-frame forwarding protocol gvrp
Parameter
Description
Parameter
Description
N/A
N/A
Defaults
This function is disabled by default.
Command
mode
Global configuration mode
Usage Guide
In the IEEE 802.1Q standard, the MAC address 01-80-C2-00-00-21 of GVRP PDUs is reserved for
future standardization. In other words, the device following the IEEE 802.1Q standard does not
forward GVRP PDUs frames. However, in actual network deployment, GVRP PDUs transparent
transmission may be required. For example, the device not enabled with GVRP needs to transmit
GVRP PDUs frames transparently to ensure proper GVRP topology calculation.
Configuration
Examples
The following example enables GVRP PDUs transparent transmission.
Ruijie(config)# bridge-frame forwarding protocol gvrp
Related
Commands
Command
Description
N/A
N/A
Platform
Description
N/A
10.2 clear gvrp statistic
Use this command to clear the GVRP statistics for re-counting.
clear gvrp statistics { interface-id | all }
Parameter
Description
Parameter
Description