Command Reference PoE Management Commands
14 PoE Management Commands
14.1 poe class-lldp enable
Use this command to configure LLDP two-event classification. Use the no or default form of this
command to restore the default setting.
default poe class-lldp enable
This function is disabled by default.
Global configuration mode
The following example enables LLDP two-event classification.
Ruijie(config)# poe class-lldp enable
Ruijie(config)# end
Ruijie#write
Use this command to enable the power over Ethernet (PoE) function on the interface. Use the no
form of this command to disable this function.
To Next Page
Loading...
Need help?
General