Command Reference OSPFv2 Commands
Configures the time delay when receiving the same LSA. The range
is from 0 to 600000 in the unit of milliseconds.
Routing process configuration mode
No action is done when the same LSA is received within the specified time.
The following example configures the time delay for the same LSA as 2seconds.
Ruijie(config)# routerospf1
Ruijie(config-router)# timers arrival-time 2000
Displays the OSPF information.
2.61 timers pacing lsa-group
Use this command to configure the LSA grouping and then refresh the whole groups as well as the
update interval for the aged link state. Use the no form of this command to restore the default setting.
timers pacing lsa-group seconds
no timers pacing lsa-group
Parameter used for LSA pacing, checksum calculation, and aging
interval.
The range is from 10 to1800 in the unit of seconds.
Routing process configuration mode
Each LSA has its own update and aging time (LSA age). If you update and age LSAs separately,
many CPU resources will be consumed. To effectively use CPU resources, you can update LSAs of a
device in batches.
You can use this command to modify the value of seconds, whose default value is 240 seconds. This
parameter needs not to be adjusted often. The optimal group pacing interval is inversely proportional
To Next Page
Loading...
Need help?
General