Ruijie RG-S29 Series User Manual

Command Reference IPv6 Commands
3.26 ipv6 redirects
Use this command to control whether to send ICMPv6 redirect message when the switch receives
and forwards an IPv6 packet through an interface. Use the no form of this command to restore the
default setting.
ipv6 redirects
no ipv6 redirects
Parameter
Description
Parameter
Description
N/A
N/A
Defaults
This function is enabled by default.
Command
Mode
Interface configuration mode.
Usage Guide
The transmission rate of any ICMPv6 error message is limited. By default, it is 10pps.
Configuration
Examples
The following example enables ICMPv6 redirection on interface GigabitEthernet 0/1.
Ruijie(config-if-GigabitEthernet 0/1)# ipv6 redirects
Related
Commands
Command
Description
show ipv6 interface
Displays the interface information.
Platform
Description
N/A
3.27 ipv6 source-route
Use this command to forward the IPv6 packet with route header. Use the no form of this command to
restore the default setting.
ipv6 source-route
no ipv6 source-route
Parameter
Description
Parameter
Description
N/A
N/A
Defaults
The ipv6 source-route command is disabled by default.
Command
Mode
Global configuration mode.
Usage Guide
Because of the potential security of the header of type 0 route, it’s easy for the device to suffer from

Ruijie RG-S29 Series Specifications

General

Brand	Ruijie
Model	RG-S29 Series
Category	Switch
Language	English