Command Reference IPv6 Commands
The packet is not forwarded to the MAC address as specified by the invalid static neighbor. The
invalid static neighbor is in inactive state. Use the show ipv6 neighbor static command to display the
state of the static neighbor.
Use the clear ipv6 neighbors command to clear all neighbors learned dynamically through NDP.
The following example configures a static neighbor on SVI 1.
Ruijie(config)# ipv6 neighbor 2001::1 vlan 1 00d0.f811.1111
3.25 ipv6 ns-linklocal-src
Use this command to set the local address of the link as the source IP address to send neighbor
requests. Use the no form of this command to use the global IP address w as the source address to
send neighbor requests.
The local address of the link is always used as the source address to send neighbor requests.
Global configuration mode.
Ruijie(config)# no ipv6 ns-linklocal-src
To Next Page
Loading...
