Ruijie RG-S29 Series

Configuration Guide IP Source Guard Commands
--------------------
1 0001.0002.0001 1.2.3.2 Infinite Static 1 Global
2 0001.0002.0002 1.2.3.3 Infinite Static 1 GigabitEthernet
0/5
3 0001.0002.0003 1.2.3.4 Infinite Static 1 Global
4 0001.0002.0004 1.2.3.5 Infinite Static 1 Global
Related
Commands
Command
Description
ip source binding
Sets the binding static user.
Platform
Description
N/A
18.5 show ip verify source
Use this command to display user filtering entry of IP Source Guard.
show ip verify source [ interface interface-id ]
Parameter
Description
Parameter
Description
interface-id
Displays user filtering entry of corresponding interface.
Defaults
N/A
Command
Mode
Privileged EXEC mode
Usage Guide
If IP Source Guard is not enabled on the corresponding interface, the printing information will be
shown on the terminal as: “IP source guard is not configured on the interface FastEthernet 0/10”
Now, IP Source Guard supports the following filtering modes:
inactive-restrict-off: the IP Source Guard is disabled on bound interfaces.
inactive--not-apply: the IP Source Guard cannot adds bound entries into filtering entries for system
errors.
active: the IP Source Guard is active.
Configuration
Examples
The following example displays user filtering entry of IP Source Guard.
Ruijie # show ip verify source
Total number of bindings: 7
NO. INTERFACE FILTERTYPE FILTERSTATUS IPADDRESS
MACADDRESS VLAN TYPE
----- -------------------- ----------- ---------------------
--------------- --------------- -------- -------------
1 Global IP+MAC Inactive-not-apply 192.168.0.127