Configuration Guide TACACS+ Commands
You must configure the aaa group server tacacs+ command before configuring this command.
To configure server address in TACACS+ group server, you must use the tacacs-server host
command in global configuration mode.
If there is no response from the first host entry, the next host entry is tried.
The following example configures a TACACS+ server group named tac1 and a TACACS+ server
address 1.1.1.1 in this group.
Ruijie(config)#aaa group server tacacs+ tac1
Ruijie(config-gs-tacacs+)# server 1.1.1.1
Configures a TACACS+ server group.
Use this command to display the TACACS+ server configuration.
Privileged EXEC mode/Global configuration/Interface configuration mode
The following example displays the TACACS+ server configuration.
Ruijie# show tacacs
Tacacs+ Server : 172.19.192.80/49
Socket Opens: 0
Socket Closes: 0
Total Packets Sent: 0
Total Packets Recv: 0
Reference Count: 0
To Next Page
Loading...
Need help?
General