Command Reference RIP Commands
command restores the setting to the default value.
The rule of configuring the no form of the redistribute command is as follows:
1. If the no form of this command specifies certain parameters, the parameters must be restored to
the default configuration.
2. If the no form of this command does not specify any parameter, the command must be deleted.
The redistribute command cannot redistribute the default route of other protocol to the RIP
process. To this end, use the default-information originate command.
The following example redistributes static routes to RIP.
Ruijie(config-router)# redistribute static
Sets the default metric of the route to be
redistributed.
default-information originate
Generates the default route in the RIP process.
Use this command to create the RIP routing process and enter the routing process configuration
mode. Use the no form of this command to restore the default setting.
No RIP process is running by default.
Global configuration mode
One RIP routing process must be defined with one network number. If a dynamic routing protocol
runs on asynchronous lines, configure the async default routing command on the asynchronous
interface.
The following example creates the RIP routing process and enters the routing process configuration
mode.
Ruijie (config)# router rip
To Next Page
Loading...
Need help?
General