Ruijie RG-S29 Series

Command Reference OSPFv2 Commands
Local address 10.0.0.37/32
Remote address 10.0.0.27/32
Transmit Delay is 1 sec, State Point-To-Point,
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
Hello due in 00:00:05
Adjacency state Full
The following table describes the fields in the output.
Field
Description
Virtual Link VLINK0 to
router
Displays the virtual link neighbors and their status.
Virtual Link State
Displays the virtual link state.
Transit area
Displays the transit area of the virtual link.
via interface
Displays the associated interface of the virtual link.
Local address
Local interface address
Remote Address
Peer interface address
Transmit Delay
Displays the transmit delay of the virtual link.
State
Interface state
Time intervals
configured
Hello, Dead, Wait, and Retransmit interval of the interface
Adjacency State
Neighbor state, where FULL means the stable state
Related
Commands
Command
Description
N/A
N/A
Platform
Description
N/A
2.59 summary-address
Use this command to configure the aggregate route out of the OSPF routing domain. Use the no form
of this command to restore the remove the aggregate route.
summary-address ip-address net-mask [ not-advertise | tag value | cost cost ]
no summary-address ip-address net-mask [ not-advertise | tag | cost]
Parameter
Description
Parameter
Description
ip address
IP address of the aggregate route
net-mask
Network mask of the aggregate route
not-advertise
Does not advertise the aggregate route. If the parameter is not
configured, the aggregate route is advertised.