Ruijie RG-S29 Series User Manual

Command Reference IPv6 Commands
Platform
Description
N/A
3.8 ipv6 mtu
Use this command to configure the MTU of IPv6 packets. Use the no form of this command to restore
the default setting.
ipv6 mtu bytes
no ipv6 mtu
Parameter
Description
Parameter
Description
bytes
MTU of IPv6 packets, in bytes. The value ranges from 1280 to 1500.
Defaults
The default configuration is the same as the configuration of the mtu command.
Command
Mode
Interface configuration mode
Usage Guide
If the size of an IPv6 packet exceeds the IPv6 MTU, the RGOS software segments the packet. For all
devices in the same physical network segment, the IPv6 MTU of the interconnected interface must be
the same.
Configuration
Examples
The following example sets the IPv6 MTU of the FastEthernet 0/1 interface to 1400 bytes.
Ruijie(config)# interface fastEthernet 0/1
Ruijie(config-if)# ipv6 mtu 1400
Related
Commands
Command
Description
mtu
Sets the MTU of an interface.
Platform
Description
This command cannot be used on Layer 2 devices.
3.9 ipv6 nd cache interface-limit
Use this command to set the maximum number of neighbors learned on the interface. Use the no
form of this command to restore the default setting.
ipv6 nd cache interface-limit value
no ipv6 nd cache interface-limit
Parameter
Description
Parameter
Description
value
Sets the maximum number of neighbors learned on
the interface, including the static and dynamic

Ruijie RG-S29 Series Specifications

General

Brand	Ruijie
Model	RG-S29 Series
Category	Switch
Language	English