Configuration Guide 802.1X Commands
Ruijie(config)# dot1x valid-ip-acct timeout 10
4.50 dot1x system disable
Use this command to disable global 802.1x. Use the no form of this command to restore the default
settings.
By default, global 802.1x is enabled.
Global configuration mode
(Optional) When the server is unreachable, disable global 802.1x, so users can access the Internet
without authentication. After the server resumes reachability, enable global 802.1x, and users have to
pass authentication before accessing the Internet.
The following example disables global 802.1x.
Ruijie(config)# dot1x system disable
This command is only supported on switches.
Use this command to display the 802.1X setting.
To Next Page
Loading...
Need help?
General